Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Modell nr: HLG-150H
Märke: Menar väl
Förpackning: Låda
Produktivitet: 20000pcs per month
Transportfordon: Ocean,Land,Air
Hemorten: Guangdong, Kina
Stödja: 5000pcs per month
Hamn: Shenzhen,Guangzhou,Hongkong
Betalning Typ: T/T,Paypal,Money Gram,Western Union
Incoterm: FOB,CIF
HLG-150H Medelvatten Vattentät LED Strömförsörjning
Produktbeskrivning
Vattentät 150W Single Output Switching Power Supply, följande modell används i stor utsträckning med Iseeled `s ledde lampor, HLG-150 H - 12, HLG-150 H -1 5, HLG-150 H -24, etc någon annan modell för speciella lampor med olika ingångsspänning.
HLG-150 H -12 Blank: IP67 betygsatt. Kabel för I / O-anslutning.
HLG-150 H- 12A: IP65 märkt. Utgångsspänning och konstant strömnivå kan justeras genom intern potentiometer.
HLG-150 H- 12B: IP67-klassad. Konstant strömnivå justerbar genom utgångskabel med 1 ~ 10Vdc eller PWM signal eller motstånd.
HLG-150 H- 12D (tillval): IP67-märkt. Timerdämpningsfunktion, kontakta MEAN WELL för detaljer.
Model |
HLG-150H-12 |
HLG-150H-15 |
HLG-150H-24 |
|
Output |
DC VOLTAGE |
12V |
15V |
24V |
CURRENT ADJ. RANGE |
Can be adjusted by internal potentiometer A type only |
|||
7.5-12.5A |
6-10A |
3.8-6.3A |
||
RATED POWER |
150W |
150W |
151.2W |
|
VOLTAGE ADJ. RANGE |
10.8-13.5V |
13.5-17V |
22-27V |
|
Input |
Voltage Range |
90-264VAC 127-370V DC |
||
Frequency Range |
47-63Hz |
|||
POWER FACTOR |
PF>0.98/115VAC, PF>0.95/230VAC, at full load (Please refer to "Power Factor Characteristic" curve) |
|||
Efficiency(Typ.)(230Vac) |
92% |
92.5% |
93.5% |
|
AC CURRENT (Typ.) |
1.7A / 115VAC 0.75A / 230VAC |
|||
INRUSH CURRENT(Typ.) |
COLD START 75A/230VAC |
|||
LEAKAGE CURRENT |
<0.75mA / 240VAC |
|||
PROTECTION |
OVER LOAD |
95~ 108% |
||
Protection type : Constant current limiting, recovers automatically after fault condition is removed |
||||
SHORT CIRCUIT |
Constant current limiting, recovers automatically after fault condition is removed |
|||
OVER VOLTAGE |
14-17V |
18-21V |
28-34V |
|
Protection type :Shut down O/P voltage, re-power on to recover |
||||
OVER TEMPERATURE |
100 ℃ up or less10 ℃ (RTH2) |
|||
Protection type : Shut down and latch off o/p voltage, recovers automatically after temperature goes down |
||||
Environment |
WORKING TEMP. |
-40 ~ +70 ℃(Refer to output load derating curve) |
||
WORKING HUMIDITY |
20 ~ 95% RH non-condensing |
|||
SAFETY |
SAFETY STANDARDS |
UL8750, CSA C22.2 No. 250.0-08, EN61347-1, EN61347-2-13 independent IP65 or IP67, J61347-1, J61347-2-13 approved ; design refer to UL60950-1, TUV EN60950-1 |
||
WITHSTAND VOLTAGE |
I/P-O/P:3.75KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC |
|||
ISOLATION RESISTANCE |
I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC / 25 / 70% RH |
|||
EMC EMISSION |
Compliance to EN55015, EN55022 (CISPR22) Class B, EN61000-3-2 Class C ( 50% load) ; EN61000-3-3 |
|||
EMC IMMUNITY |
Compliance to EN61000-4-2,3,4,5,6,8,11, EN61547, EN55024, light industry level (surge 4KV), criteria A |
|||
Others |
MTBF |
192.2K hrs min. MIL-HDBK-217F (25℃ ) |
||
DIMENSION |
228*68*38.8mm (L*W*H) |
|||
PACKING |
1.15Kg; 12pcs/14.8Kg/0.8CUFT |
|||
Note |
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Derating may be needed under low input voltages. Please check the static characteristics for more details. 5. Type A only. 6. Safety and EMC design refer to EN60598-1, CNS15233, GB7000.1, FCC part18. 7. Length of set up time is measured at cold first start. Turning ON/OFF the power supply may lead to increase of the set up time. 8. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. 9. Refer to warranty statement. |
1. Alla parametrar som inte speciellt nämns mäts vid 230VAC ingång, nominell belastning och 25 omgivningstemperatur. Notera
2. Rippel och ljud mäts vid 20MHz bandbredd genom att använda en 12 "twisted pair-wire terminerad med en parallell kondensator med 0.1uf och 47uf.
3. Tolerans: inkluderar inställningstolerans, linjereglering och belastningsreglering.
4. Derating kan behövas vid låga ingångsspänningar. Kontrollera de statiska egenskaperna för mer information.
5. Endast typ A.
6. Säkerhet och EMC-design hänvisar till EN60598-1, CNS15233, GB7000.1, FCC part18.
7. Inställningstidens längd mäts vid kall första start. Om du slår PÅ / AV strömförsörjningen kan det leda till en ökning av inställd tid.
8. Strömförsörjningen anses vara en komponent som ska användas i kombination med slututrustning. Eftersom EMC-prestanda påverkas av färdig installation måste de slutliga utrustningstillverkarna ompröva EMC-direktivet om den fullständiga installationen igen.
9. Se garantianslutningen.Produktkategorier : LED tillbehör > Meanwell vattentät strömförsörjning
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.